The minimum cubic inch capacity of the plaster ring that will be installed on the box is _ inch.
A 4 11/16 × 11/4inch square metal box with a 2-gang plaster ring is to be installed as the box assembly. A separate equipment grounding conductor is not required for this installation. The wiring method used is 10 AWG wire installed in EMT. Remember: MC cable contains a grounding conductor! 2.0 Refer to the legend and partial wiring plan in Figure 116.201. Two 3" × 2" metal switch boxes will be ganged together to form a 2-gang switch box for the switches. The wiring method used is 12 AWG MC cable (with external connectors). 2 3/4 Refer to Figure 116.201, shown above. A 4 × 11/4 inch square metal box with a 2-gang plaster ring is to be installed as the box assembly. The wiring method used is 12 AWG wire installed in EMT. 6.75 Refer to the legend and partial wiring plan in Figure 116.201.
Plaster ring code#
Select N/A (not applicable) if there is not a Code reference for this. 200.7(C)(1) The Code section that specifies that white conductors in a cable assembly must be re-identified where used to "feed" a switch is _. "Weatherproof" and "GFCI protected" only A 125-volt, 15- or 20-ampere receptacle installed outside a house is required to be _. The Code reference(s) for this requirement is _. Theplans require that the outside receptacle for this dwelling be GFCI protected.
The single-pole switch to the left of the sliding doors controls _. the exterior light fixture Refer to Figure 116.109. 70 The NEC® at 314.27(C) states that listed outlet boxes or outlet box systems that are listed and marked for the purpose shall be permitted to support ceiling-suspended fans (paddle type) that weigh _ pounds or less.
210.52(A)(2)(2) When determining the spacing between wall receptacles, the Code section that specifies whether or not the slidingpanels in glass doors in a dwelling are counted in the maximum spacing is _. not specified in the NEC® Along a wall line (not separated by doors), the maximum spacing between receptacles in the dining room in a cafeteria is _. arc-fault circuit interrupter (AFCI) The NEC® at Section 210.12 requires that _ protection be provided for all electrical outlets in residential bedrooms. 12 Along a wall line (not separated by doors), the maximum spacing between receptacles in the dining room in a house is _ feet.
0 kommentar(er)
